DTF Transfers FAQ

DTF stands for direct-to-film. Your design is printed on a special film with an adhesive powder, and you press it onto fabric with heat. DTF handles full color, fine detail, and both light and dark fabrics, in almost any size or shape. See DTF transfers.

Here's how: 1. Pre-press the garment for a few seconds to remove moisture and wrinkles. 2. Place the transfer. Use heat-resistant tape on hats or uneven surfaces. 3. Press at 302°F (150°C) for 15 seconds with firm pressure (about 40 psi). You may need small adjustments for different fabrics. 4. Let it cool completely, then peel off the film. 5. Optional: cover with parchment paper and press again for a few seconds to set the transfer.

A heat press gives the most even results, and a home iron also works. Test on one or two pieces before pressing a full batch.

Cold peel. Let the transfer cool completely after pressing, then peel the film off slowly.

They're built to last through 50+ washes without peeling, cracking, or fading when you follow these care steps:

• Turn the garment inside out.
• Wash in cold or warm water on a gentle cycle with mild detergent.
• Skip bleach and fabric softener.
• Air dry or tumble dry on low.
• Don't iron directly over the print.

Cotton, polyester, and blends, on both light and dark colors. Pressing settings may need small adjustments depending on the fabric.

DTG (direct-to-garment) prints ink straight onto the shirt, which works best on cotton and usually needs pre-treatment for dark fabrics. DTF prints your design on film first, then you press it on, so it works on more fabrics and colors, and you can stock transfers and press them whenever you need.